Micro Device Modeling Method and Design for Manufacturability

Zheng Liu, Bo Sun

Abstract


The micro device designing flow begins with the mask design currently, which is not intuitive for designer and sometime made them confused. As a result, the manufacturability is hard to prove in advance with the traditional designing way. Especially for surface micro-machined device with multiple structural layers, the 2D mask design cannot ensure the fabrication of complex 3D device with high yields reliably. The rise of structural designing strategies gave a direction to change the traditional habit. On the other hand, the top-down method provides the advanced designing flow, which begins with the system level design. However, there still some key technologies to study further because of the novel design procedure. To improve the manufacturability of micro device, the designing flow based on design for manufacturability methodology is presented, which draw on the advantages and experience of the mechanical design method. The key technologies on the structural design level, the processes planning level and the fabricating level are introduced correspondingly. In addition, we present the framework to implement the method.

 

DOI: http://dx.doi.org/10.11591/telkomnika.v11i8.3081

 


Keywords


Design for manufacturability; Micro device; Optimal design; Computer aided design

Full Text:

PDF

Refbacks

  • There are currently no refbacks.


Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

Indonesian Journal of Electrical Engineering and Computer Science (IJEECS)
p-ISSN: 2502-4752, e-ISSN: 2502-4760
This journal is published by the Institute of Advanced Engineering and Science (IAES) in collaboration with Intelektual Pustaka Media Utama (IPMU).

shopify stats IJEECS visitor statistics