Modeling and validation of lithium-ion battery with initial state of charge estimation

Ali Mohsen Alsabari, M.K Hassan, Azura CS, Ribhan Zafira

Abstract


The modeling of lithium-ion battery is an important element to the management of batteries in industrial applications. Various models have been studied and investigated, ranging from simple to complex. The second-order equivalent circuit model was studied and investigated since the dynamic behavior of the battery is fully characterized. The simulation model was built in Matlab Simulink using the Kirchhoff Laws principle in mathematical equations, while the battery's internal parameters were identified by using the BTS4000 (Battery tester) device. To estimate the full state of charge (SOC), the initial state of charge (SOC0) must be identified or measured. Hence, this paper seeks for the SOC estimation by using experimental terminal voltage data and SOC with Matlab lookup table. Then, the simulated terminal voltage, as well as the SOC of the battery are compared and validated against measured data. The maximum relative error of 0.015 V and 2% for terminal voltage and SOC respectively shows that the proposed model is accurate and relevant based on the error analysis.

Keywords


Battery modeling; Battery tester; BTS4000; SOC; SOC0

Full Text:

PDF


DOI: http://doi.org/10.11591/ijeecs.v21.i3.pp1317-1331

Refbacks

  • There are currently no refbacks.


Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

Indonesian Journal of Electrical Engineering and Computer Science (IJEECS)
p-ISSN: 2502-4752, e-ISSN: 2502-4760
This journal is published by the Institute of Advanced Engineering and Science (IAES) in collaboration with Intelektual Pustaka Media Utama (IPMU).

shopify stats IJEECS visitor statistics