Design of Low Power Low Noise Amplifier using Gm-boosted Technique

Maizan Muhamad, Norhayati Soin, Harikrishnan Ramiah

Abstract


This paper presents the development of low noise amplifier integrated circuit using 130nm RFCMOS technology. The low noise amplifier function is to amplify extremely low noise amplifier without adding noise and preserving required signal to a noise ratio. A detailed methodology and analysis that leads to a low power LNA are being discussed throughout this paper. Inductively degenerated and Gm-boosted topology are used to design the circuit. Design specifications are focused for 802.11b/g/n IEEE Wireless LAN Standards with center frequency of 2.4 GHz. The best low noise amplifier provides a power gain (S21) of 19.841 dB with noise figure (NF) of 1.497 dB using the gm-boosted topology while the best low power amplifier drawing 4.19mW power from a 1.2V voltage supply using the inductively degenerated.

Keywords


LNA, CMOS, Noise Figure, Integrated Circuits

Full Text:

PDF


DOI: http://doi.org/10.11591/ijeecs.v9.i3.pp685-689

Refbacks

  • There are currently no refbacks.


Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

Indonesian Journal of Electrical Engineering and Computer Science (IJEECS)
p-ISSN: 2502-4752, e-ISSN: 2502-4760
This journal is published by the Institute of Advanced Engineering and Science (IAES) in collaboration with Intelektual Pustaka Media Utama (IPMU).

shopify stats IJEECS visitor statistics