Sensitivity Factor Based Optimal Location of SVC on Transmission Network

T. D. Sudhakar

Abstract


In modern days power system are becoming highly unpredictable, so low voltages and blackout are becoming common scenario. The voltage limits are affected because the system is operated close to its stability limits. To improve the voltage profile new generating plants have to be developed, which are restricted due to economic an environmental limitations. To overcome these limitations and use the existing network to the maximum, FACTS devices are used. In this paper, SVC a FACTS device is used to improve the voltage profile of the network. To decide the location of the SVC, voltage sensitivity analysis method is used. FACTS devices are used to compensate both real and reactive power. To demonstrate this IEEE 14 bus and 39 bus are considered. The complete simulation is done using PSAT version 2.1.6 in Matlab 7.10.0 (R2010 a).

Full Text:

PDF


DOI: http://doi.org/10.11591/ijeecs.v12.i7.pp4915-4923

Refbacks

  • There are currently no refbacks.


Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

Indonesian Journal of Electrical Engineering and Computer Science (IJEECS)
p-ISSN: 2502-4752, e-ISSN: 2502-4760
This journal is published by the Institute of Advanced Engineering and Science (IAES) in collaboration with Intelektual Pustaka Media Utama (IPMU).

shopify stats IJEECS visitor statistics