Study on the Cutting Prediction of Supercritical Material
Abstract
The technology of the artificial neural network (ANN) was applied in the research of supercritical material cutting. Two-dimensional Gaussian surfaces of the three cutting elements and workpiece surface hardness had been established fitting through JMP software. Base on the orthogonal milling experiments, the rules of cutting forces variation were forecasted, as well as the effect to the hardness on workpiece surface. The cutting parameters selected according to the process were built, providing an important basis for the optimization of machining conditions. The prediction results were in good agreement with the experimental results.
DOI: http://dx.doi.org/10.11591/telkomnika.v11i9.3265
Keywords
Full Text:
PDFRefbacks
- There are currently no refbacks.
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
Indonesian Journal of Electrical Engineering and Computer Science (IJEECS)
p-ISSN: 2502-4752, e-ISSN: 2502-4760
This journal is published by the Institute of Advanced Engineering and Science (IAES) in collaboration with Intelektual Pustaka Media Utama (IPMU).