LTE RF receiver modeling and each part testing with MATLAB simulink

Fatima Faydhe al azzawi

Abstract


fourth generation cellular network based on Long Term Evaluation (LTE) air interface. LTE is specifically designed for packet data communications, where the emphasis of the technologies high spectral efficiency, high peak data rates, low latency, and frequency flexibility. In this paper a LTE physical layer design and implemented using MATLAB codes and Simulink, where MATLAB codes generate the 64 QAM transmitting signal and simulating LTE frames while Simulink model perform the physical layer which including the band limiting, free space path loss adding, channel, RF receiver, demodulation, 10-bit ADC, DC offset cancellation, saving data to preform EVM measurements, and viewing the spectrum signal after each block, finally QAM with multi –order tested under AWGN.

Keywords


LTE, physical layer, RF receiver.

Full Text:

PDF


DOI: http://doi.org/10.11591/ijeecs.v14.i3.pp1251-1257

Refbacks



Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

Indonesian Journal of Electrical Engineering and Computer Science (IJEECS)
p-ISSN: 2502-4752, e-ISSN: 2502-4760
This journal is published by the Institute of Advanced Engineering and Science (IAES) in collaboration with Intelektual Pustaka Media Utama (IPMU).

shopify stats IJEECS visitor statistics